Century 115/208 - 230 VAC, 5.4 - 5.2/10.4 A, 3/4 HP, High-Torque Rigid-Base Electric Motor - C520

Hello, there! Thank you for your inquiry about the Honeywell RTH5160D1003/E thermostat. To set the R-switch position and insert the R-wire(s) on this thermostat, first turn off the power. Remove the thermostat cover and locate the R terminal. After that, set the R-switch position according to your specific heating and cooling system setup. Take the R wire(s) from your HVAC system and insert them into the R terminal on the thermostat's terminal block. Once the R-wire(s) are inserted, carefully place the thermostat cover back into position and secure it with screws or by snapping it back into place. Finally, turn the power supply back on. We hope this information helps. Thank you for reaching out to PlumbersStock. Have a good day!

Hi! Thank you for your inquiry about the Honeywell RTH5160D1003/E thermostat. To disconnect the wires and remove the old wall plate, use a screwdriver to release wires from terminals. Then, use a wire label to identify each wire as it is disconnected. The letter on the wire label should match the letter on the terminal. To prevent wires from falling back into the wall, wrap the wires around a pencil. Feel free to check page 4 of this installation guide for your reference. We hope this information helps. Thank you for choosing PlumbersStock. Have a nice day!

Hi! Thank you for asking about the Honeywell White Simple Display Non-Programmable Digital Thermostat (RTH5160D1003/E). Just follow the following steps: (1) Safety First: make sure the power is turned off at the breaker box. Use a non-contact voltage tester to confirm that there's no electricity running through the wires. (2) Check the Connection: Gently tug on each wire to ensure they're connected inside the wire nut. A loose connection can cause arcing, which is a fire hazard. (3) Re-Twist if Necessary: You need to redo the connection, twist the wires together tightly (in a clockwise direction), and make sure all exposed copper is covered by the wire nut. We hope this helps. Thank you for seeking an answer from PlumbersStock. Have a great day!

Hi! Thank you for your inquiry about the Honeywell RTH5160D1003/E thermostat. To set the system operation mode, begin by pressing the Menu button.Then, use the Mode (+) button to navigate through the available system modes until you reach the desired mode. Finally, press the Done button to confirm the selection. Note that available system modes vary by model and system settings. Feel free to check page 10 of this installation guide for your reference. We hope this information helps. Thank you for choosing PlumbersStock. Have a nice day!